Daihen OTC ARXIS pulse P403L, Руководство пользователя, Страница: 57 / 188

W
IRE
I
NCHING
W
ELDING
O
PERATION
C
HAPTER
5
55
Chapter 5 W
elding Operation
6.
Open the main tap of shield gas.
●
When the gas regulator is equipped with a pressure gauge, open the main tap by checking the pressure gauge
until the appropriate pressure is obtained.
7.
Turn the flow rate adjustment knob to "OPEN", and adjust the flow rate of shield gas.
8.
Select "Gas check" to stop the gas supply.

The gas check stops and the screen returns to the "Operation" screen.
5.4 Wire Inching
This section explains the inching operation (feeding operation) of the wire.
1.
Straighten the torch cable.

Bent cable may cause feeding failure of the wire or wire bending.
•
Do not look into the tip of the welding torch during the inching operation. Do not bring
the tip of the welding torch to face, eyes, or body.
The wire may abruptly burst out, resulting in an injury.
•
Keep hands, fingers, hair and clothes away from the feed roll of the wire feeder.
It may cause an entanglement.
Inching menu on touch panel
10 mm