Device Operation 7
After completing IMU calibration, the motor starts working while PTZ returns to the center
automatically.
Thus, PTZ camera has been installed completely.
3.2
Picture Acquisition Mode
This chapter mainly introduces how to acquire pictures from SD card and ground control station.
3.2.1
SD Card
Step 1: Open SD card plug with a hand, as shown in
错误
!
未找到引用源。
.
Figure 3-3
Step 2: Press SD card gently, and SD card will pop up. Pull out SD card.
Step 3: Insert SD card into card reader, and connect the card reader with computer.
With the card reader, copy videos in SD card to the computer, and save them.
3.2.2
Ground Control Station
Ground control station and the device are in the same network segment by default, which need
no configuration.
One set of device has been paired before leaving factory, so the user doesn’t need to pair again. If
several devices are mixed and cannot be distinguished, please pair them before operation. For
details, please refer to drone user’s manual.
Step 1: Turn on power supply of ground control station, remote control and aircraft.
