8
2 Installation
2.1 Device Installation
Note:
Please cut off the device power first when installing Micro SD card.
Please make sure the installation surface can at least sustain 3X weight of the camera and the
bracket.
Figure 2-1
Please refer to the steps listed below.
Step1
Use the inner hex wrench (provided) to loosen the three inner hexagon screws in the dome cover
and then open the cover.
Step 2
Install SD card
Note:
You need to implement this step if there is a Micro SD card slot and it needs to use Micro SD
card for the device.
Find the SD card slot location which is shown in Figure 2-2, open the upper cover, adjust the
direction of Micro SD card, insert the Micro SD card into the slot and make the upper cover back
in position.
