10
4.1 Installing the Camera
1. Remove the camera, the mounting template, and the hardware package from the box.
2. Use the Hex Key to remove the locking screw from the dome enclosure. Then, separate the
dome enclosure from the pedestal.
4.2 Inserting the Micro SD Card (optional)
1. Loosen four screws inside the dome enclosure with a Phillips screwdriver and remove the
compression cover.
Figure 4-2
2. Loosen three screws on the dome body with a Phillips screwdriver and remove the lower
assembly of the dome enclosure.
Figure 4-3
3. Insert the Micro SD card (maximum of 128 GB) into the slot shown above.
4. Replace the lower dome enclosure and the seal ring and tighten the three screws. Then, replace
the compression cover and secure to the dome enclosure with the four Phillips head screws.
