User’s Manual
9
3.2.2 Installing Casing
Cut off the power before installation.
Handle carefully to avoid damaging the sprayed coating of the casing.
Keep the Barriers for vehicle access control of the same direction on a straight line.
Unpack the packaging box.
Step 1
Place the casing on the foundation, and make the working direction of the arm vertical
Step 2
to the vehicle movement direction (we recommend to placing a layer of 3mm rubber
under the casing to reduce vibration).
Use the key to open the door, lower the panel with control box, and then place metal
Step 3
plates on the foundation bolts.
Adjust the horizontal and vertical positions of the casing, and then tighten the nuts with
Step 4
a wrench.
3.2.3 Installing Radar
Open the top cover, and pull out the access panel.
Step 1
Open the electrical plate, and cut off the power.
Step 2
Unscrew the butterfly nuts, and remove the radar bracket.
Step 3
Place the radar in the holes of the casing, with the cable outlet facing up.
Step 4
Secure the radar with the radar packet, and then screw the butterfly nuts.
Step 5
Install radar (1)
Figure 3-5
Before installation
After installation
1: Butterfly nut; 2: Radar bracket.
Apply silicone sealant around the radar on the outer surface of the casing for
Step 6
waterproofing.
