User’s Manual
70
Figure 7-20 Monitor station
Step 2
Press
and
to select the monitor station that you want to configure, and then press
.
Step 3
Configure the parameters.
Press
and
to alter the options. Press
to confirm the setting and move to the
next submenu.
Table 7-20 Monitor station settings
Submenu
Setting
STATE
●
ACTIVE
: The PSTN number is enabled.
●
ISOLATE
: The PSTN number is set but temporarily locked.
MODE
Set the digital protocol for each service center number (Only
CONTACT
ID
for now).
TEST DATE
Set the date when to test PSTN.
TEST TIME
Set the specific time when to test PSTN.
Step 4
Press
to return to the
MONITOR STATION
menu.
Then you can continue with programming other monitor stations (up to three), or press
o return to the
MONITOR STATION
menu from where you can press
and
to
move to the next menu or press
to exit from the installer menu.
7.20 Vocal Messages
Procedure
Step 1
After entering the installer menu, press
and
to scroll up and down until you reach
the
VOCAL MESSGAES
menu.
Figure 7-21 Vocal message
Step 2
Press
to enter the programming mode.
Step 3
Press
and
to select the vocal message that you want to configure, and then press
.
Step 4
Configure the parameters.
Press
and
to alter the options. Press
to confirm the setting and move to the
next submenu.
Содержание DHI-ARC3008C
