66
In
Global Settings
, select
Enabled
in
Mode
to enable mirroring.
Step 2
In
Port Configuration
, select
Source
or
Destination
according to the actual situation.
Step 3
Select the following four ways for source port.
Both: Enable the port as the source address of mirror.
Disable: Disable the port as the source address of mirror.
Rx only: The port only mirrors receiving data, rather than sending data.
Tx only: The port only mirrors sending data, rather than receiving data.
Select the
Destination
box to set the port to be destination.
Click
Save
.
Step 4
Ping
4.6
With Ping protocol, you can check whether the device with a specified IP address can be accessed,
and check whether the network connection fails.
Select
Maintain > Common > Ping
.
Step 1
Ping
Figure 4-9
Enter the IP address, and then click
Ping
.
Step 2
Functions of Network Management System
4.7
4.7.1
Enabling Function and Logging in to Platform
The functions of network management system is to support iLinksView network management
platform. You can enable or disable the network management function and change the username
and password.
The username and password must be the same as those of ILinksView network management
platform.
Network management function is enabled by default. Here are the default username and password.
