13
Meanwhile, connection quantity is N (representing the quantity of connected clients) on AP status
display page.
3.3
Adjustment of Wireless Coverage Dead Angle
When client adopts direct wireless communications with central AP (access point) because
surveillance point is blocked seriously, two sets of CPE realize back-to-back connection and carry out
angle adjustment. Actual connection diagram is as follows.
Figure 3-3 Networking Diagram of Coverage Dead Angle Adjustment
1. Two back-to-back equipment shall adopt wired connection.
2. Downlink client equipment is set to be access point; uplink central AP equipment is set to be client.
3. For specific configuration of single equipment, please refer to setting wizard configuration.
Network Bridge
Equipment
Mode
Frequency
(MHz)
Network
Name
Password
A&B Pairing
A
Client
Default
Dahua1
Dahautech1
B
AP
5745MHz(149) Dahua1
Dahautech1
C&D Pairing
C
Client
Default
Dahua2
Dahautech2
D
AP
5825MHz(165) Dahua2
Dahautech2
Corresponding Table of Pairing Across Network
By default, client doesn’t need to set equipment frequency, but differentiates by
network name and password. High-end user can set client input frequency at wireless setting page.
