Dahua ASI7214X, Руководство пользователя

Страница: 46 / 93

39
4
Web Operation
The access controller can be configured and operated on the web. Through the web you can set
network parameters, video parameters, and access controller parameters; and you can also maintain
and update the system.
Initialization
You need to set a password and an email address before logging in to the web for the first time.
Open IE web browser, and enter the IP address (the default address is 192.168.1.108) of the
access controller in the address bar, and then press the Enter key.

IE 8 and later are supported. Otherwise you might not log in to the web.

Make sure that the computer used to log in to the web is in the same LAN with the device.

7-inch model B access controllers of have dual NICs. The default management address
for ETH1 is 192.168.1.108, and for ETH2 is 192.168.2.108.
Initialization
Enter the new password, confirm password, enter an email address, and then tap Next .

For security, keep the password properly after initialization and change the password
regularly.

The password should consist of 8 to 32 non-blank characters and contain at least two
types of characters among upper case, lower case, number, and special character
(excluding ' " ; : &). Set a password of high security level according to the password
strength prompt.

When you need to reset the administrator password by scanning the QR code, you need
an email address to receive the security code.