7
4 Device Installation
This section details installing the fisheye camera to a wall or ceiling. Note that the wall or ceiling must
be capable of supporting a minimum of three (3) times the weight of the camera and a bracket (if
used).
Warning
: DO NOT connect the camera to the power supply during installation.
Warning
: For units intended to be installed outdoors: All wiring connecting to the unit must be routed
separately inside a different permanently earthed metal conduits (not supplied).
Warning
: Install external interconnecting cables in accordance to NEC, ANSI/NFPA70 (for US
application) and Canadian Electrical Code, Part I, CSA C22.1 (for CAN application) and in
accordance to local country codes for all other countries. Branch circuit protection incorporating a 20
A, 2-pole Listed Circuit Breaker or Branch Rated Fuses are required as part of the building installation.
A readily accessible 2-pole disconnect device with a contact separation of at least 3 mm must be
incorporated.
Warning:
DO NOT remove the protective film from the dome until the installation is complete to
protect the dome from distortions from fingerprints, oil, grease or other contaminants.
Note
: Dahua recommends attaching a “drip loop” (flex or hard conduit) during installation to ensure
condensation does not form in the mount or the conduit.
4.1 Installing an SD Card
1.
Ensure the camera is disconnected from the power supply.
2.
Use the Torx wrench to loosen the three screws on the dome enclosure. Remove dome
enclosure from the dome body.
3.
Lift the SD Card slot cover.
4.
Align the SD Card with the slot and place the SD Card into the slot.
5.
Push the SD Card slot cover back into place.
4.2 Mounting the Camera
Figure 4-1
1. Remove the camera, the mounting template, and the hardware package from the box.
2.
Use the Torx wrench to loosen the three screws on the dome enclosure. Remove dome
enclosure from the dome body.
3.
Apply the mounting template to the mounting medium. Ensure the TOP of the template is
directed to the desired direction.
