Dahua Technology DHI-XVR5108HS-4K, Руководство пользователя

Страница: 57 / 318

User's Manual
49
Parameter Description
and RTSP. You need to configure a default Ethernet port (usually the
Ethernet port 1 by default) to request the services from the device end
such as DHCP, Email and FTP. If one of the two Ethernet ports is
disconnected as detected by networking testing, the system network
status is regarded as offline.
Fault Tolerance: Two Ethernet ports share one IP address. Normally only
one Ethernet port is working and when this port fails, the other port will
start working automatically to ensure the network connection.
When testing the network status, the network is regarded as offline only
when both of the two Ethernet ports are disconnected. The two
Ethernet ports are used under the same LAN.
Load Balance: Two network cards share one IP address and they are
working at the same time to share the network load averagely. If one of
them fails, the other can continue working normally.
When testing the network status, the network is regarded as offline only
when both of the two Ethernet ports are disconnected. The two
Ethernet ports are used under the same LAN.
The Device with single Ethernet port does not support this function.
Default Ethernet Port
In the Ethernet Card list, select an Ethernet port as a default port.
This setting is available only when the Multi-address is selected in the Net
Mode list.
IP Version
In the IP Version list, you can select IPv4 or IPv6. Both versions are
supported for access.
MAC Address Displays the MAC address of the Device.
DHCP
Enable the DHCP function. The IP address, subnet mask and default
gateway are not available for configuration once DHCP is enabled.
If DHCP is effective, the obtained information will display in the IP
Address box, Subnet Mask box and Default Gateway box. If not, all
values show 0.0.0.0.
If you want manually configure the IP information, disable the DHCP
function first.
If PPPoE connection is successful, the IP address, subnet mask, default
gateway, and DHCP are not available for configuration.
IP Address
Enter the IP address and configure the corresponding subnet mask and
default gateway.
IP address and default gateway must be in the same network segment.
Subnet Mask
Default Gateway
DNS DHCP Enable the DHCP function to get the DNS address from router.
Preferred DNS In the Preferred DNS box, enter the IP address of DNS.
Alternate DNS In the Alternate DNS box, enter the IP address of alternate DNS.