Dahua Technology DHI-ITC214-PH3A, Руководство пользователя, Страница: 21 / 78

User’s Manual
16
5
Web Operations
After mounting the Device, you need to power on the Device, connect it to the network, and make
proper settings, then you can get the desired detection results.
The actual interface might vary depending on the model you purchased and the version of software.
The figures in this manual are only for reference, and the actual interface shall prevail.
Basic Web Configurations 5.1
5.1.1 Recommended PC Configuration
Requirements of PC for logging in to the web interface of the Device is shown in the following table.
Table 5-1 Recommended PC configuration
PC Components Recommended Configuration
Operating System Windows 7 and newer.
CPU Intel core i3 and newer.
Graphics Card Intel HD Graphics and above.
Memory 2GB and more.
Display 1024×768 and higher.
Browser Internet Explorer 8/9/10/11, Chrome33/44, and Firefox 49.
5.1.2 Initialization
Skip this section if you have initialized the Device with ConfigTool by following instructions in "4.1
Initialization."

Initialization is required for first-time login or logging in after restoring factory default settings.

Make sure that both PC IP and device IP are in the same network segment, otherwise it might
fail to enter initialization interface.
Set IP address, subnet mask, and gateway of PC and device respectively. Step 1

If there is no router in the network, distribute IP address of the same segment.

If there is router in the network, configure the corresponding gateway and subnet
mask.
The IP address is 192.168.1.108 by default.
Use ping ***.***. ***. *** (device IP address) command to check whether network is Step 2
connected.
Open browser, enter the IP address of the Device in the address bar, and then press the Enter Step 3
key.