Daewoo POWER BLENDER, Руководство пользователя

Страница: 10 / 14

Cleaning Tips
Use a small brush (not supplied) to remove particles lodged beneath the
blades. Care must be taken when cleaning the blade assembly as they are
sharp.
To aid the removal of lodged food or food that has dried onto the jars or blade
assembly, fill the jar 2/3 full with warm soapy water and put through the
blending cycle and repeat with clean water.
CAUTION: Do not attempt to remove blades from the blade assembly for
cleaning.
Troubleshooting
Symptom Possible reason and solution
Motor doesn’t start or attachment
doesn’t rotate.
Ensure the tabs on the jar are correctly
located in motor unit and the jar is turned fully
clockwise
The mains plug is not inserted into the socket
or the socket is not switched on (if applicable)
Food is chopped unevenly. The jar may be overfilled - reduce the amount
of ingredients below the ‘Max Fill’ mark
The ingredients may be stuck, - remove and
shake the jar to redistribute contents
Food is too finely chopped or
watery. The food has been over processed, for best
results use short pulses
Not enough ingredients and/or too much liquid
Cannot achieve
‘snow’ from ice
cubes.
For best result use ice straight from the
freezer. Try using short blends instead of one
long one and a little water.
Jar is leaking. Make sure the lid or blade assembly (as
applicable) is properly attached to the cup and
the threads are not misaligned
Unit doesn
’t turn on
Make sure the unit is plugged in.
Make sure the blade assembly is properly
assembled to the jar and that is not
misaligned
Doesn’t blend well
Pulse ingredients for best results, for frozen
foods, blend in 2 second intervals.
Lid/blade assembly will not
properly align to the jar Set the jar on a level surface. Place the lid or
blade assembly on top of the jar and align the
threads so that the lid/blades sit flat on the jar.
Twist clockwise so that the lid/blades evenly
align to the jar until you have a tight seal.