4
INSTALLATION INSTRUCTIONS
Removing transit bolts
1. Before operating the washer,
remove the transit bolts(4ea)
along with the rubber.
•
If the bolts are not removed, it
may cause heavy vibration,
noise and malfunction.
2. Unscrew the 4 bolts with the
spanner wrench supplied. Keep
the 4 bolts and spanner wrench
for future use.
•
Whenever the appliance is
transported, the transit bolts
must be installed.
3. Close holes with supplied cap
holders.
Location of your washer
• Check location where the washer will be installed. Make sure you have everything necessary for correct installation.
• Do not place or store your washer below 0°C (32°F) to avoid any damage from freezing.
• Do not place or store laundry products on top of washer at any time.
• Install the washer on a solid floor. If the washer is installed on an unsuitable floor,
it could make considerable noise, vibrate severely and cause a malfunction.
If the washer is not level, adjust leg up or down according to instructions below.
• Ventilation openings must not be obstructed by carpeting when the
washer is installed on a carpeted floor.
• Leave some space (right & left : 1 inch, rear : 4 inch).
• In case of built-in installation, the distance between top of the washer
and bottom of upper plate should be at least 0.11 inch(3mm).
Drain Hose
Washer
Laundry
Tub
Approx.
1 inch
Level adjustment
①
If the washer is installed on an unsuitable floor, it could make
considerable noise, vibrate and cause a malfunction.
②
Adjust the level of washer using adjustable legs.
• Please check if there is any gap between the four adjustable legs and the floor.
• Install unit leveler and turn adjustable leg with the enclosed spanner wrench to adjust the level of washer and or
swaying of washer.
• After the adjustment is finished, turn the locking nuts up
tightly so that the washer maintains the adjustment.
③
Make it sure that the washer does not sway when
you press down the four corners of the washer’s top plate.
NOTE
There should be no swaying of washer and all the
adjustable legs should be firmly seated to the floor.
Fixing Nut
adjustable leg