7
7. OPERATION
6.1 Charging the battery (Fig. 1)
The battery is protected from exhaustive discharge. An integrated protective circuit automatically
switches off the equipment when the battery is flat. In this case the bit chuck will cease to turn.
WARNING!
Do not press the ON/OFF switch anymore if the protective circuit has actuated. Thismay
damage the battery.
1. Check that your mains voltage is the same as that marked on the rating plate of the battery char-
ger. Plug the battery charger in the plug socket and connect the charging cable to the charging
connection. The charging process starts as soon as the charging cable is connected to the charging
adapter.
2. The red LED (6) will come on to indicate that the battery pack is being charged.
3. When the charging control lamp (6) all three lights lit, said charging is complete. Important! The
handle may become a little warm during the charging process. This is normal.
If the battery pack fails to charge, please check whether there is voltage at the socket-outlet and
check for proper contact with the charging contacts in the battery charger.
If the battery still fails to charge, send the battery charger and the screwdriver to our customer
services department.
Timely recharging of the battery pack will help it serve you well for a long time.
You must recharge the battery pack when you notice that the power of the screwdriver drops.
Never allow the battery pack to become fully discharged. This will cause it to develop a defect.
6.2 Changeover switch (Fig. 2/Item 9)
The slide switch above the ON/OFF switch is for setting the direction of rotation of the cordless
screwdriver and for preventing the cordless screwdriver from being switched on inadvertently.
You can select between clockwise and counterclockwise rotation. Change the direction of rotation
only when the equipment is at a standstill. If you fail to observe this point, the gearing may become
damaged. When the slide switch is in the middle position, the ON/OFF switch is blocked.
6.3 ON/OFF switch (Fig. 2 / Item 8)
Press the On/Off switch to switch the cordless screwdriver on. Release the ON/OFF switch to
switch off the tool.
6.4 LED lamp
The LED lamp (2)and(14) can be used in poor lighting conditions to illuminate the area where you
want to screw.
Button(8)control the LED lamp(2) ON/OFF
Button(13)control the LED lamp(14) ON/OFF
Don't put the light point-blank you and other people's eyes
6.5 Angle setting (Fig. 3/Item 3)
The screwdriver can be locked into 2 different angle settings. To do so, press the locking button
(3) and move the screwdriver into the desiredposition (Press the release button and by turning
the handle (5) to the right). Then release the locking button (3).
