9
Installation Instructions
Assembling the Burners
WARNING
• Never attempt to operate the cooktop with any of the burner parts removed.
• Do not attempt to adjust the burner air mixture settings. All adjustments are preset at the factory.
1. Remove the burner heads, burner rings, burner caps,
and grates from their shipping packages.
2. Assemble the burners as shown below.
When assembling the burner components:
• match the sizes of components together, i.e., the large
burner cap with the large burner ring.
• center and turn each piece back and forth until it drops
completely into place.
• The burners will not properly function unless all of the
burner pieces are correctly seated.
3. Gently set the grates on top of the spill tray. Make sure
that the feet are placed in the indentations located in
the spill tray.
* Model RNCT305G
, has a different style of burner on the
left, rear of the cooktop.
The burner base is permanently attached to the unit and cannot be removed by the user.
Igniter
Burner cap
(bottom shown)
Burner ring
Burner base
Fit igniter in
hole
CAUTION
: Top of
igniter
is sharp
RNCT305G Left Rear Burner
SimmerSear™ Burner Assembly
Inner burner cap
(bottom shown)
Outer burner cap
Burner ring
Burner base
Line up
indentations with
pins.
Standard Burner Assembly
Igniter
Burner cap
(bottom shown)
Burner ring
Burner base
Fit igniter in hole
CAUTION
: Top of
igniter
is sharp
Standard Burner Assembly on the
