Dacor Renaissance RNHP3018S, Инструкция по использованию и уходу

Страница: 6 / 12

4
To Temporarily Turn the
AUTO-ON
Feature
OFF:
1. Press and release the
FAN
button until the fan
shuts OFF.
• If the temperature under the hood remains hotter
than 140°F (60°C), the fan will start to protect the
electronics from scortching.
• Once the temperature drops below 130°F
(54°C), the fan will automatically shut OFF.
Turning on the Lights
1. Press the
LIGHTS
button C once to turn the lights
on the high setting.
2. Press the
LIGHTS
button twice to set the lights to
low .
3. Press the
LIGHTS
button three times to turn the
lights off .
Resetting the Clean Filter Light
After 50 hours of fan use, the
CLEAN FILTER
light
E will illuminate to remind you to clean the
filters.
To Turn the Light OFF:
1. At the same time, press and hold the TIMER
button D and
FAN
button B for three seconds
or until the light turns off.
2. Clean the filters if necessary. For instructions,
follow Cleaning the Filters on the next page.
Important Operating Tips
• Always use the fan when cooking.
• Turn the fan on a few minutes before cooking to
establish an airflow current in the room.
• Adjust the fan speed according to the volume and
weight of the food you are cooking.
• Shut nearby windows and doors, turn off ceiling
fans, and close nearby heating and air conditioning
vents to reduce drafts around the hood.
• Place your largest pots and pans on the back burn-
ers when possible.
• In the interest of safety, heat oils and fats slowly.
Energy Saving Tips
• Keep the filter system and hood surfaces free of
grease and debris to improve efficiency.
• Select cookware of the proper size, material, and
construction for the cooking task.
WARNING
Never operate the range hood without the filters in place. Also, do not use the hood with grimy or grease-laden filters.
Personal injury, fire, or damage to the range hood could result.
Using the Hood Features
Control the fan(s), lights, and timer by pressing the
illuminated blue buttons on the
control panel
. See
image below.
Using the Fan
The fan has four (4) speed settings, then cycles to
OFF.
The speed is indicated by the number of lights glow-
ing on the
fan speed display bar
A .
1. Press the
FAN
button B to turn the fan ON.
2. Press it again to increase the speed,
or to turn the fan off:
3. Press the
FAN
button until the fan turns OFF.
As you repeatedly press and release the
FAN
button, the fan speed increases. After the high-
est speed is pressed, the fan will cycle to OFF.
Setting the Timer
Your hood is equipped with a
timer
to automatically
turn the fan and/or lights OFF after ten minutes.
To Set the Timer:
1. Set the fan and/or lights to your desired setting.
2. Press the
TIMER
button D , and
the button will light, indicating the timer is ON.
• The fan and/or the lights will turn OFF after about
ten minutes.
To Turn the Timer OFF:
1. Press the TIMER button. The light on the TIMER
button will shut off, indicating that the timer is OFF.
Introducing the AUTO-ON Safety Feature
To protect the electronics from heat damage, the
fan automatically turns ON when the temperature
rises above 140°F (60°C). The fan speed increases
with the heat.
Operating Instructions
A B C D
E
F
an
L
ights
t
imer
Control Panel
Fan Speed
Display Bar
Clean Filter
Light