Dacor DH3006, Инструкция по использованию и уходу

Страница: 7 / 12

5
Care and Cleaning
WARNING
To avoid the risk of fire, electric shock or personal
injury:
• Turn off power to the hood at the circuit breaker panel
or fuse box before cleaning.
• Clean the hood only in the manner specified.
• Use only the types of cleaning solutions specified in
this manual.
• Thoroughly dry the filters immediately after cleaning.
• Turn off the cooktop or range and make sure that the
appliance and range hood are cool before cleaning.
• To avoid damage to the fan, do not reinstall damaged
filters (see page 6 for replacement part numbers).
CAUTION
Always wipe stainless steel (silver colored) surfaces with
the grain. To prevent scratching, do not use abrasive
cleaners or scrubbers on stainless steel or glass
surfaces.
Proper cleaning is necessary to ensure safe opera-
tion and maintain hood performance and appear-
ance. The frequency of cleaning should be adjusted
according to the type and amount of cooking. Best
results will be achieved by cleaning soiled compo-
nents as soon as possible.
Cleaning Stainless Steel Surfaces
Clean stainless steel surfaces with a mild solution
of detergent or dishwashing soap and warm water.
Rinse and dry with a soft, lint-free cloth.
You may also use Dacor Stainless Steel Cleaner. Use
it according to the directions on the package.
Cleaning the Light Lens
Use a mild glass cleaner to remove smudges on the
light fixture lens. You can also clean it with Dacor
Cooktop Cleaning Creme. Use it according to the
directions on the package.
Cleaning the Filters
Clean the filters a minimum of every two months.
To Remove the Filters:
The filters A are located on the bottom of the hood,
directly above the cooking surface.
1. Hold the filter in place with one hand and push
back on the release lever B with the other.
2. While pushing back on the release lever, lower the
filter out of the hood.
To Clean the Filters:
Hand wash the filters in hot water with a mild
detergent solution or dishwashing soap. You can
also place them in an automatic dishwasher. Dry the
filters completely before reinstalling.
To Reinstall the Filters:
1. Insert tabs on the end of each filter opposite the
release lever into the slots toward the back of the
hood (above the hood rim). The release lever must
be facing down.
2. Push back on the release lever while sliding the
free end of the filter into the filter opening.
3. Release the lever.
b
A