32
Precaution and warnings “during the installation” of the equipment
- This equipment can only be unpacked and installed by an Alliage authorized technician, under the
penalty of losing the warranty, as only them possess the information, the proper tools and the required
training for carrying out this task.
- Manufacturer does not take this responsibility for damage or accidents caused due to a bad installation
performed by a technician non-authorized by Alliage.
- Only after the equipment is installed and properly tested by the Alliage authorized technician, it will
be ready to start the working operations.
- Install the unit in a place where it will not be damaged by the pressure, temperature, humidity, direct
sunlight, dust, salts.
- The unit should not be submitted to inclination, excessive vibrations, or blows (including during
transportation and handling).
- This equipment was not planned for use in an environment where vapors, anesthetic mixtures
inflammable with air, or oxygen and nitrous oxide can be detected.
- Check the voltage of the equipment at the moment of executing the electrical installation.
- Before the first use and/or after long interruptions from work such as vacations, clean and disinfect
the equipment.
Precautions and warnings “during the use” of equipment
- The equipment should only be operated by duly enabled and trained technicians (Dental Surgeons,
Capacitated Professionals).
- If any maintenance should be required, only use services of the Alliage Authorized Technical
Assistance.
- Although this equipment has been planned in accordance with the standards of electromagnetic
compatibility, it can, in very extreme conditions, cause interference with other equipment. Do not use
this equipment together with other devices very sensitive to interference or with devices which create
high electromagnetic disturbance.
- Do not expose the plastic parts to contact with chemical substances, use in the routines of dental
treatment, such as: acids, mercury, acrylic liquids, amalgams, etc.
- Do not let the handpiece with insert into the tip support in order to avoid accidents.
- Avoid the light conductor terminal touch with the resin to be polymerized.
- While using the Curing Light verify that the output of the light pen has no residues that may obstruct
the light beam.
- Use appropriated techniques for minimizing the effects of the contraction of the photo polymerized
material and also of the temperature on the applied region; these techniques consist of a proportional
detachment from the expected effect, which means that detaching the tip from the activated region,
the power and the temperature tends to diminish.
- We recommend the use of a mask and goggles for applying the bicarbonate jet.
- Avoid leaving sodium bicarbonate in the container for long periods without use.
The effect of residual humidity in the air may alter the properties of the powder and cause blocking.
Manufacturer shall not be responsible for:
Use of the equipment differing from that for which it is intended.
- Damages caused to the equipment, the professional and/or the patient by the incorrect installation
and erroneous procedures of maintenance, differing from those described in these Instructions for
use which come with the equipment or by the incorrect operation of it.
PRECAUTIONS, RESTRICTIONS AND WARNINGS
