DAB EVOSTA2 OEM Series, Инструкция по установке и обслуживанию

Страница: 22 / 368

ENGLISH
20
7.2 Transport
Avoid subjecting the products to needless impacts and collisions.
To lift and transport the circulator use lifting devices with the aid
of the pallet supplied with it
(if contemplated).
7.3 Weight
The adhesive plate on the packaging indicates the total weight of the circulator.
8. INSTALLATION
Always switch off the mains power supply before working on the electrical or mechanical part of the
system. Wait for the warning lights on the control panel to go out before opening the appliance. The
capacitor of the direct current intermediate circuit remains charged with dangerously high voltage even
after the mains power has been turned off.
Only firmly cabled mains connections are admissible. The appliance must be earthed (IEC 536 class 1,
NEC and other applicable standards).
Ensure that the voltage and frequency on the data plate of the EVOSTA2 OEM circulator are the same as
those of the power mains.
8.1 Mechanical installation
Figure 2: Mounting EVOSTA2 OEM
The arrows on the pump housing indicate the flow direction through the pump. See fig. 1, pos. A.
1. Fit the two gaskets when you mount the pump in the pipe. See fig. 1, pos. B.
2. Install the pump with a horizontal motor shaft. See fig. 1, pos. C.
3. Tighten the fittings.
8.2 User Interface Position
Always install the EVOSTA2 OEM circulator with the motor shaft in a horizontal position.
Install the electronic control device in a vertical position.
A
B
C