DAB PUMPS PWM 201, Инструкция по установке и обслуживанию

Страница: 117 / 635

ENGLISH
115
8. RESET AND DEFAULT SETTINGS
8.1 General system reset
To reset PMW press and hold the 4 buttons simultaneously for 2 Sec. This operation does not delete settings memorised by the
user.
8.2 Default settings
The inverter leaves the factory with a series of pre-set parameters, which can be modified according to user requirements. Each
modification to settings is automatically saved in the memory, while the user, when required, can always restore the default
conditions (see Ripristino delle impostazioni di fabbrica par. 8.3).
8.3 Restoring default settings
To restore the default settings, switch off the inverter, wait for complete shutdown of the fans and display, then press and hold
buttons “SET” and “+” and power up the unit; only release the two buttons when the text "EE" is displayed.
In this case the default settings are restored (writing and reading on EEPROM of the default settings saved permanently on the
FLASH memory).
After setting all parameters, the inverter resumes normal operation.
After restoring default settings, all system parameters should be reconfigured (current, gain, minimum frequency, setpoint
pressure etc.) as per the initial installation procedure
.
Default settings
PWM 203
202 - 201
PWM 407
405 - 404
PWM 420 415 -
410
Installation
note
Identifier Description Value
LA Language ITA ITA ITA
SP Setpoint pressure [bar] 3,0 3,0 3,0
P1 Setpoint P1 [bar] 2,0 2,0 2,0
P2 Setpoint P2 [bar] 2,5 2,5 2,5
P3 Setpoint P3 [bar] 3,5 3,5 3,5
P4 Setpoint P4 [bar] 4,0 4,0 4,0
FP Test frequency in manual mode 40,0 40,0 40,0
RC Rated current of electric pump [A 0,0 0,0 0,0
RT Direction of rotation 0 (UVW) 0 (UVW) 0 (UVW)
FN Rated frequency [Hz] 50,0 50,0 50,0
OD Type of system 1 ( Rigid ) 1 ( Rigid ) 1 ( Rigid )
RP Pressure drop for restart [bar] 0,5 0,5 0,5
AD Address 0 (Auto) 0 (Auto) 0 (Auto)
PR Pressure sensor
1
(501 R 25 bar)
1
(501 R 25 bar)
1
(501 R 25 bar)
MS Measurement system 0 (International ) 0 (International)
0
( International )
FI Flow sensor 0 ( Absent ) 0 ( Absent ) 0 ( Absent )
FD Pipeline diameter [inch] 2 2 2
FK K-factor [pulse/l] 24,40 24,40 24,40
FZ Setting zero flow frequency 0 0 0
FT Minimum shutdown flow [ l/min] 5 5 5
SO Dry running factor 22 22 22
MP Minimum pressure pump stop [bar] 0,0 0,0 0,0
TB Delay for water failure block [s] 10 10 10
T1 Shutdown delay [s] 2 2 2
T2 Shutdown delay [s] 10 10 10
GP Proportional gain coefficient 0,6 0,6 0,6
GI Integral gain coefficient 1,2 1,2 1,2
FS Maximum rotation frequency [Hz] 50,0 50,0 50,0
FL Minimum rotation frequency [Hz] 0,0 0,0 0,0