D-Link xStack DES-3810, Справочное руководство, Страница: 387 / 477

xStack
®
DES-3810 Series Layer 3 Managed Ethernet Switch Web UI Reference Guide
374
Figure 10-26 SMTP Settings window
The fields that can be configured are described below:
Parameter Description
SMTP State
Use the radio button to enable or disable the SMTP service on this device.
SMTP Server Address
Enter the IP address of the SMTP server on a remote device. This will be the device that
sends out the mail for you.
SMTP Server Port (1-
65535)
Enter the virtual port number that the Switch will connect with on the SMTP server. The
common port number for SMTP is
25
, yet a value between
1
and
65535
can be chosen.
Self Mail Address
Enter the e-mail address from which mail messages will be sent. This address will be the
“from” address on the e-mail message sent to a recipient. Only one self-mail address can
be configured for this Switch. This string can be no more that 64 alphanumeric characters.
Add A Mail Receiver
Enter an e-mail address and click the
Add
button. Up to eight e-mail addresses can be
added per Switch. To delete these addresses from the Switch, click the corresponding
Delete
button in the SMTP Mail Receiver Address table at the bottom of the window.
Subject
The subject of the test mail.
Content
The content of the test mail.
Click the
Apply
button to accept the changes made for each individual section.
Click the
Add
button to add a new entry based on the information entered.
Click the
Delete
button to remove the specific entry.
SNTP
The Simple Network Time Protocol (SNTP) is a protocol for synchronizing computer clocks through the Internet. It
provides comprehensive mechanisms to access national time and frequency dissemination services, organize the
SNTP subnet of servers and clients, and adjust the system clock in each participant.