xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch
Parameter Description
From and To
Select ports to be initialized.
Port
A read-only field indicating a port on the Switch.
MAC Address
The MAC address of the Switch connected to the corresponding port, if any.
Auth PAE State
The Authenticator PAE State will display one of the following:
Initialize, Disconnected,
Connecting, Authenticating, Authenticated, Aborting, Held, ForceAuth, ForceUnauth,
and
N/A.
Backend State
The Backend Authentication State will display one of the following:
Request, Response,
Success, Fail, Timeout, Idle, Initialize,
and
N/A.
Port Status
The status of the controlled port can be
Authorized, Unauthorized,
or
N/A.
Initializing Ports for MAC Based 802.1x
To initialize ports for the MAC side of 802.1x, the user must first enable 802.1x by MAC address in the
Advanced Settings
window. Click
Security > 802.1X > Initialize Port(s)
to open the following window:
Figure 11- 14. Initialize Ports (MAC based 802.1x)
To initialize ports, first choose the switch in the switch stack by using the
Unit
pull-down menu, then the range of ports in the
From
and
To
field. Then the user must specify the MAC address to be initialized by entering it into the
MAC Address
field and
checking the corresponding check box. To begin the initialization, click
Apply
.
NOTE:
The user must first globally enable 802.1X in the
Advanced Settings
window in the
Configuration
folder before initializing ports. Information in the
Initialize Ports Table
cannot
be viewed before enabling 802.1X.
213
Содержание xStack DES-3800 Series
Страница 50: ...xStack DES 3800 Series Layer 3 Stackable Fast Ethernet Managed Switch 35 ...
Страница 340: ......
Страница 357: ......
Страница 360: ......
