D-Link TM DES-6500, Справочное руководство по интерфейсу командной строки

Страница: 218 / 267

31
DVMRP C
OMMANDS
The DVMRP commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command Parameters
config dvmrp ipif <ipif_name 12>
all
metric <value 1-31>
state [enabled/disabled]
probe <sec 1-65535>
neighbor_timeout <sec 1-65535>
enable dvmrp
show dvmrp neighbor ipif <ipif_name 12>
ipaddress <network_address>
show dvmrp nexthop ipif <ipif_name 12>
ipaddress <network_address>
show dvmrp routing_table ipaddress <network_address>
show dvmrp ipif <ipif_name>
disable dvmrp
Each command is listed, in detail, in the following sections.
config dvmrp
Purpose Used to configure DVMRP on the switch.
Syntax config dvmrp [ipif <ipif_name>/all] {metric <value>/probe
<second>/neighbor_timeout <second>/state [enabled/disabled]
Description This command is used to configure DVMRP on the switch.
Parameters
<ipif_name>
−
The name of the IP interface for which DVMRP is to be
configured.
all
−
Specifies that DVMRP is to be configured for all IP interfaces on the
switch.
metric <value>
−
Allows the assignment of a DVMRP route cost to the
above IP interface. A DVMRP route cost is a relative number that
represents the real cost of using this route in the construction of a
multicast delivery tree. It is similar to, but not defined as, the hope count
in RIP. The default is 1.
probe <second>
−
DVMRP defined an extension to IGMP that allows
routers to query other routers to determine if a multicast group is present
on a given router subnetwork or not. This is referred to as a ‘probe’.
The default value is 10 seconds.
neighbor_timeout <second>
−
The time period for which DVMRP will
hold Neighbor Router reports before issuing poison route messages.
The default value is 35 seconds.
state [enabled/disabled]
−
Allows DVMRP to be enabled or disabled.
Restrictions Only administrator-level users can issue this command.