D-Link SECURICAM Network DCS-3220G, Руководство пользователя, Страница: 31 / 143

31
Important: Some ISPs block access to port 80 and other commonly used
Internet ports to conserve bandwidth. Check with your ISP so that you can
open the appropriate ports accordingly. If your ISP does not pass traffic on port
80, you will need to change the port the camera uses from 80 to something
else, such as 800. Not all routers are the same, so refer to your user manual
for specific instructions on how to open ports.
Using & Configuring the DCS-3220G with a
NAT Router (continued)
Enter the ports in the Virtual
Server section of your router
that correspond ot the ports
you have configured on the
DCS-3220G .
192.168.0.102
Follow these steps to configure your router’s Virtual Server settings:
Repeat the above steps adding ports 5002 and 5003 to both the Public and
Private Port sections. A check mark appearing before the entry name will
indicate that the ports are enabled.
•
Click Enabled .
•
Enter a different name for each entry.
•
Enter your camera’s local IP Address (e.g., 192.168.0.102 in
the example in step on page 28) in the Private IP field.
•
Select Both under Protocol Type ( TCP and UDP )
•
If you are using the default camera port settings, enter 80 into
the Public and Private Port section, click Apply .
•
Scheduling should be set to Always so that the camera images
can be accessed at any time.
Please make sure to check
the box on this line to enable
settings