D-Link NetDefend DFL-260E, Справочное руководство

Страница: 263 / 328

3.93. PPPoETunnel
Description
A PPPoE interface is a PPP (point-to-point protocol) tunnel over an existing physical Ethernet
interface. Its IP address is dynamically assigned.
Properties
Name Specifies a symbolic name for the interface.
(Identifier)
EthernetInterface The physical Ethernet interface that connects to
the PPPoE server network.
IP The host name to store the assigned IP address in.
Network The network from which traffic should be routed
into the tunnel.
DNS1 IP of the primary DNS server. (Optional)
DNS2 IP of the secondary DNS server. (Optional)
Username Specifies the username to use for this PPPoE
tunnel.
Password The password to use for this PPPoE tunnel.
ServiceName Specifies the PPPoE server service name used to
distinguish between two or more PPPoE servers
attached to the same network. (Optional)
PPPAuthNoAuth Allow no authentication for this tunnel. (Default:
No)
PPPAuthPAP Use PAP authentication protocol for this tunnel.
User name and password are sent in plaintext.
(Default: Yes)
PPPAuthCHAP Use CHAP authentication protocol for this tunnel.
(Default: Yes)
PPPAuthMSCHAP Use MS-CHAP authentication protocol for this
tunnel. (Default: Yes)
PPPAuthMSCHAPv2 Use MS-CHAP v2 authentication protocol for this
tunnel. (Default: Yes)
DialOnDemand Enable Dial-on-demand which means that the
PPPoE tunnel will not be setup until traffic is sent
on the interface. (Default: No)
ActivitySensing Specifies if the dial-on-demand should trigger on
inbound or outbound traffic or both. (Default:
BiDirectional)
IdleTimeout Idle timeout in seconds for dial-on-demand.
(Default: 3600)
Chapter 3: Configuration Reference
263