60
D-Link M15 User Manual
Section 3 - Configuration
IPv4/IPv6 Rules
To begin, use the drop-down menu to select whether it is an
ALLOW
or
DENY
rule. You can also choose to turn filtering
OFF
.
If you want to remove a rule, click
in the Delete column. If you wish to edit
a rule, click
in the Edit column. If you wish to create a new rule, click the
Add Rule
button.
Go to
Features
>
Firewall
, then click the
IPv4 Rules
tab or the
IPv6 Rules
tab
to configure rules for traffic filtering.
To configure the Firewall Advanced settings, click the
Advanced
link. Refer
to
If you click
Edit
or
Add Rule
, the following options will appear:
Name
Enter a name for the rule.
Source IP
Address Range
Enter the source IP address range (e.g. 1.1.1.1-1.1.1.2 for IPv4 or
2001::1-2001::2 for IPv6) that the rule will apply to. Using the drop-
down menu, specify whether it is a
WAN
or
LAN
IP address. Both a
single IP address and a range of IP addresses can be entered.
Destination IP
Address Range
Enter the destination IP address range (e.g. 1.1.1.1-1.1.1.2 for IPv4 or
2001::1-2001::2 for IPv6) that the rule will apply to. Using the drop-
down menu, specify whether it is a
WAN
or
LAN
IP address. Both a
single IP address and a range of IP addresses can be entered.
Protocol & Port
Range
Select the protocol of the traffic to allow or deny (
Any, TCP, or UDP
)
and then enter the range of ports (e.g. 21-23) that the rule will apply
to. Select
Any
to allow/deny all types of traffic regardless of the port
number.
