DXS-3600 Series 10GbE Layer 2/3 Switch Hardware Installation Guide
27
Switch>enable
Switch#configure terminal
Switch(config)#username NewUser password 12345
Switch(config)#username NewUser privilege 15
Switch(config)#line console
Switch(config-line)#login local
Switch(config-line)#end
Switch#
Figure 4-5 To create a user account
In the example above:
1. At the CLI command prompt, enter the
enable
command to enter the
Privileged EXEC Mode
. Press
Enter
.
2. Enter the
configure terminal
command to enter the
Global Configuration Mode
. Press
Enter
.
3. Enter the
username NewUser password 12345
command. Press
Enter
. This will create a user account with
the username of NewUser and a password of 12345.
4. Enter the
username NewUser privilege 15
command. Press
Enter
. This will configure this user account to
have
Administrative
(
15
) privileges.
5. Enter the
line console
command to enter the
Line Configuration Mode
. Press
Enter
.
6. Enter the
login local
command. Press
Enter
. This specifies that the local line requires login credentials.
7. Enter the
end
command to exit back to the
Privileged EXEC Mode
.
NOTE:
Passwords are case sensitive. Usernames can be up to 19 characters in length.
Passwords can be up to 16 characters in length.
Configuring the IP Address
Each switch must be assigned its own IP Address, which is used for communication with an SNMP network manager
or other TCP/IP applications. The switch’s console default IP address is 10.90.90.90/8, and the management port
default IP address is 192.168.0.1/24. You can change the switch’s default IP address to fit into your networking
address range.
The IP address of the Switch must be configured before it can be managed, by the user, via the Web User Interface.
An example to change the IP address of the Switch to ‘10.50.50.50’, using a subnet mask of ‘255.0.0.0’:
Switch>enable
Switch#configure terminal
Switch(config)#interface vlan 1
Switch(config-if)#ip address 10.50.50.50 255.0.0.0
Switch(config-if)#end
Switch#
Figure 4-6 To change the IP address
1. At the CLI command prompt, enter the
enable
command to enter the
Privileged EXEC Mode
. Press
Enter
.
2. Enter the
configure terminal
command to enter the
Global Configuration Mode
. Press
Enter
.
3. Enter the
interface vlan 1
command to enter the
Interface Configuration Mode
. Press
Enter
.
4. Enter the
ip address 10.50.50.50 255.0.0.0
command to change the IP address and mask. Press
Enter
.
5. Enter the
end
command to exit back to the
Privileged EXEC Mode
.
The Switch can now be configured and accessed through Telnet or the Web-based management.
The Switch’s IP address can also automatically be obtained by using the BOOTP or DHCP protocol.
Connecting using SNMP
The switch can be managed with an SNMP-compatible console program. The Simple Network Management Protocol
(SNMP) operates on the Application Layer of the OSI model and is designed specifically for managing and monitoring
Содержание DXS-3600 Series
Страница 1: ...SBG 3000 Series Web Smart Switch Hardware Installation Guide ...
Страница 55: ......