DXS-3600 Series 10GbE Layer 2/3 Switch Hardware Installation Guide
15
Installing the Switch into a Rack
This section is used to guide the user through installing the switch into a switch rack. The switch can be mounted in a
standard 19"(1U) rack using the provided mounting brackets. Use the following diagram as a guide.
Figure 2-2 Fasten mounting brackets on the Switch
How to install the mounting brackets onto the switch (Figure above) and onto the rack (Figure below):
1. Fasten the mounting brackets
A
and
B
to the sides of the switch using the screws provided, as seen in the
figure above.
2. Fasten the mounting bracket
C
in the appropriate open space in the rack using the screws provided, as seen
in the figure below.
3. Simply slide the switch (fastened bracket
B
into fastened bracket
C
) into the rack.
4. Lastly, fasten mounting bracket
A
to the rack using the screws provided.
Figure 2-3 Installing the Switch in a rack
Make sure that there is adequate space around the Switch to allow for proper air flow, ventilation, and cooling.
Installing Transceivers into the Transceiver Ports
The switch is equipped with small form-factor pluggable plus (SFP+) ports that can be used to connect various other
networking devices to this switch that do not support the standard copper wiring connection. These ports are generally
used to connect this switch to networking devices that can only be accessed via an optical fiber connection and is
C
A
B
Содержание DXS-3600 Series
Страница 1: ...SBG 3000 Series Web Smart Switch Hardware Installation Guide ...
Страница 55: ......
