4 Configuration
D-Link DXS-1210 Series User Manual
4
4
3
3
Figure 4.72 – L2 Features > Loopback Detection Settings
Loopback Detection State:
Enable or disable loopback detection. The default is
disabled.
Mode:
Select either Port-based or VLAN-based.
Enabled VLAN ID List:
Enter
the VLAN ID for loop detection. This only takes effect when the
VLAN-based
is selected in the
Mode
drop-down list.
Interval (1-32767):
Set a Loop Detection Interval between
1
and
32767
seconds. The default is 2
seconds.
Trap State:
Select
to enable or disable the loopback detection trap state.
Action:
Select
Shut-down
or
None
for the loopback detection.
From Port / To Port:
Enter a consecutive group of ports to be configured starting with the selected port.
State:
Use the drop-down menu to toggle between
Enabled
and
Disabled.
Default is
disabled
.
Click
Apply
to save your settings.
L2 Features > Link Aggregation
The Link Aggregation page allows you to view and configure the link aggregation settings.
Figure 4.73 – L2 Features > Link Aggregation
System Priority (1-65535):
Enter
the system’s priority value you want to use. This value must be between 1
and 65535. By default, this value is 32768. The system priority determines which ports can join a port-
channel and which ports are put in the stand-alone mode. The lower value has a higher priority. If two or
more ports have the same priority, the port number determines the priority
Load Balance Algorithm:
Specify
the load balancing algorithm that will be used. Options to choose from
are
Source MAC
,
Destination MAC
,
Source Destination MAC
,
Source IP
,
Destination IP
, and
Source
Содержание DXS-1210 Series
Страница 1: ...D X S 1 2 1 0 S e r i e s L 21 0G i g a b i t E t h e r n e t S w i t c hS e r i e s V e r 1 1 0 ...
Страница 2: ......
Страница 23: ...4 Configuration D Link DXS 1210 Series User Manual 1 17 7 Figure 4 24 User Guide Micro Site ...
Страница 119: ......
