D-Link DWS-4000 Series, Справочник команд интерфейса командной строки, Страница: 541 / 566

533
Routing
R
OUTING
Table 46: DHCP Relay Log Messages
Component Message Cause
DHCP relay REQUEST hops field more than config value The DHCP relay agent has processed a DHCP
request whose HOPS field is larger than the
maximum value allowed. The relay agent will not
forward a message with a hop count greater than
4.
DHCP relay Request's seconds field less than the config value The DHCP relay agent has processed a DHCP
request whose SECS field is larger than the
configured minimum wait time allowed.
DHCP relay processDhcpPacket: invalid DHCP packet type:
%u\n The DHCP relay agent has processed an invalid
DHCP packet. Such packets are discarded by the
relay agent.
Table 47: Routing Table Manager Log Messages
Component Message Cause
Routing Table
Manager RTO is full. Routing table contains 8000 best
routes, 8000 total routes. The routing table manager, also called “RTO,”
stores a limited number of best routes, based on
hardware capacity. When the routing table
becomes full, RTO logs this alert. The count of total
routes includes alternate routes, which are not
installed in hardware.
Routing Table
Manager RTO no longer full. Bad adds: 10. Routing table
contains 7999 best routes, 7999 total routes. When the number of best routes drops below full
capacity, RTO logs this notice. The number of bad
adds may give an indication of the number of route
adds that failed while RTO was full, but a full
routing table is only one reason why this count is
incremented.
Table 48: VRRP Log Messages
Component Message Cause
VRRP Changing priority to 255 for virtual router with VRID
1 on interface 0/1 When the router is configured with the address
being used as the virtual router ID, the router’s
priority is automatically set to the maximum value
to ensure that the address owner becomes the
VRRP master.
VRRP Changing priority to 100 for virtual router with VRID
1 on interface 0/1 When the router is no longer the address owner,
the sofware reverts the router’s priority to the
default.
VRRP vrrpPacketValidate: Invalid TTL VRRP ignored an incoming message whose time
to live (TTL) in the IP header was not 255.