D-Link DWS-1008, Руководство по эксплуатации продукта

Страница: 414 / 502

D-Link DWS-1008 User Manual
Displaying RF Detect Data
To display information about the APs detected by an individual switch, use the following command:
show rfdetect data
You can enter this command on any DWS-1008 switch in your network.
DWS-1008# show rfdetect data
Total number of entries: 197
Flags: i = infrastructure, a = ad-hoc
c = CCMP, t = TKIP, 1 = 104-bit WEP, 4 = 40-bit WEP, w = WEP(non-WPA)
BSSID Vendor Type Port/Radio/Ch Flags RSSI Age SSID
--------------------------------------------------------------------------------------------------------------------
00:07:50:d5:cc:91 D-Link intfr 3/1/6 i----w -61 6 r27
00:07:50:d5:dc:78 D-Link intfr 3/1/6 i----w -82 6 r116
00:09:b7:7b:8a:54 Cisco intfr 3/1/2 i----- -57 6
...
Displaying the APs Detected by an AP Radio
To display the APs detected by an AP radio, use any of the following commands:
show rfdetect visible mac-addr
show rfdetect visible ap
ap-num
[radio {1 | 2}]
show rfdetect visible dap dap-num [radio {1 | 2}]
To following command displays information about the rogues detected by radio 1 on AP port 3:
DWS-1008# show rfdetect visible ap 3 radio 1
Total number of entries: 104
Flags: i = infrastructure, a = ad-hoc
c = CCMP, t = TKIP, 1 = 104-bit WEP, 4 = 40-bit WEP, w = WEP(non-WPA)
BSSID Vendor Type Ch Flags RSSI Age SSID
------------------------------------------------------------------------------------------------------------------------
00:07:50:d5:cc:91 D-Link intfr 6 i----w -61 6 r27
00:07:50:d5:dc:78 D-Link intfr 6 i----w -82 6 r116
00:09:b7:7b:8a:54 Cisco intfr 2 i----- -57 6
...