DWR-980
Wireless AC1200 4G LTE Router with VDSL2 Support,
Gigabit Ethernet Ports, and 2 FXS Ports
User Manual
Configuring via Web-based Interface
Connections Setup
In this menu you can configure basic parameters of the router's local area network and configure
connection to the Internet (a WAN connection).
WAN
On the
Connections Setup
/ WAN
page, you can create and edit connections used by the router.
By default, Ethernet, VDSL, and ADSL connections of the
Dynamic IPv4
type are configured in
the system. They are assigned to the WAN and DSL ports of the router correspondingly. You can
edit these connections or delete them.
!
Please reboot the router after creating, editing, or removing an ADSL WAN connection.
Figure 54. The
Connections Setup / WAN
page.
To create a new connection, click the
ADD
(
) button in the
Connections List
section. On the
opened page, specify relevant parameters.
To edit an existing connection, in the
Connections List
section, left-click the relevant line in the
table. On the opened page, change the parameters and click the
APPLY
button.
To disconnect a connection and establish it again, select the checkbox located to the left of the
relevant line in the table and click the
RECONNECT
button.
On the
Basic
tab, mandatory settings of a WAN connection are displayed. To view all available
settings of the needed WAN connection, go to the
All Settings
tab.
Page
70
of 266
