D-Link DWR-956M, Руководство пользователя

Страница: 111 / 132

Access Control -- IP Address Configuration
This is used to add a firewall rule.
Protocol: The protocol for the firewall rule. This can be
HTTP , TELNET ,
FTP , SAMBA , ICMP , TFTP , SNMP , SSH , TCP or UDP .
Choosing the HTTP , TELNET , FTP , TFTP , SSH , TCP or UDP options displays other
options on the page, and these are documented below.
Access Control: The access control interface for the firewall rule.
IP Protocol Type: The protocol type for the firewall rule.
This can be
IPv4 , IPv6 or IPv4&6 .
Enable: Whether to enable or disable the firewall rule. Tick this to enable
the firewall rule. The default is un-ticked.
Source IP: The source IP address(es) for the firewall rule.
Enter a single IP address for the source address, or enter a range of
addresses in the beginning and end boxes.
Action: The action for the firewall rule. This can be ACCEPT or DROP.
Protocol: HTTP, TELNET, FTP, TFTP, SSH, TCP or UDP
Port: The port number for the firewall rule.
Click
Back to go back to the previous page, click Apply to apply the settings and
click Refresh to refresh the page.