D-Link DES-3226L, Руководство пользователя, Страница: 50 / 110

50 Web User Guide
Example #3: show port interface
Use this command for a specific port. The output shows whether the port is the mirror or the
probe port, what is enabled or disable on the port, etc.
(Console) #show port 0/4
Admin Physical PhysicalLink Link LACP
Intf Type Mode Mode Status Trap Mode
---- ---- ------ -------- -------------- ---- ----
0/4 Mirror Enable Auto Down Enable Enable
(Console) #show port 0/5
Admin Physical PhysicalLink Link LACP
Intf Type Mode Mode Status Trap Mode
---- ---- ------ -------- -------------- ---- ----
0/5 Probe Enable Auto Down Enable Enable
Example #4: show monitor session 1
(Console) #show monitor session 1?
<cr> Press Enter to execute the command.
(Console) #show monitor session 1
Session ID Admin Mode Probe Port Mirrored Port
---------- ---------- ---------- -------------
1 Enable 0/5 0/4
Example #5: (Config) monitor session 1 mode
To set up port mirroring, specify the monitor session, then the mode.
(Console)(Config) #monitor?
session Configure port mirroring.
(Console)(Config) #monitor session?
<1-1> Session number.
(Console)(Config) #monitor session 1?
destination Configure the probe interface.
mode Enable/Disable port mirroring session.
source Configure the source interface.
(Console)(Config) #monitor session 1 mode?
<cr> Press Enter to execute the command.
(Console)(Config) #monitor session 1 mode