D-Link DES-3226L, Руководство пользователя, Страница: 32 / 110

32 Web User Guide
Quick Starting the Networking Device
NOTE:
Before you use the information in this section, ensure that you have upgraded to the
latest firmware. See “Upgrading the Switch Firmware” on page 31.
1. Read “Installing the Hardware” on page 19 for the connectivity procedure. In-band connectivity
allows access to the D-Link software locally or from a remote workstation. You must configure the
device with IP information (IP address, subnet mask, and default gateway).
2. Turn the Power ON.
3. Allow the device to load the software until the login prompt appears. The device initial state is
called the default mode.
4. When the prompt asks for operator login, do the following steps:
 Type
admin
at the login prompt. Since a number of the Quick Setup commands
require administrator account rights, D-Link suggests logging into an administrator
account.

Do not enter a password because the default mode does not use a password.
 The CLI User EXEC prompt is displayed.

Enter
enable
to switch to the Privileged EXEC mode from User EXEC.
 Enter
configure
to switch to the Global Config mode from Privileged EXEC.

Enter
exit
to return to the previous mode.
 Enter
?
to show a list of commands that are available in the current mode.
System Information and System Setup
This section describes the commands you use to view system information and to setup the
network device. Table 5 contains the Quick Start commands that allow you to view or
configure the following information:
z
Software versions
z Physical port data
z
User account management
z IP address configuration
z
Uploading from Networking Device to Out-of-Band PC (Only XMODEM)
z Downloading from Out-of-Band PC to Networking Device (Only XMODEM)
z
Downloading from TFTP Server
z Restoring factory defaults
If you configure any network parameters, you should execute the following command:
copy system:running-config nvram:startup-config
This command saves the changes to the configuration file. You must be in the correct mode to
execute the command. If you do not save the configuration, all changes are lost when a you
power down or reset the networking device.