14
D-Link DAP-3712 User Manual
Section 2 - Installation
Configuring the Second DAP-3712 in Client Mode
1. Follow steps 1-4 of the instructions above to power on
the device. Launch the Setup Wizard to configure the
device in Client Mode.
2. To avoid an IP address conflict, change the IPv4 address
so that it is different from the first DAP-3712’s IP address
(for instance, by changing it to
192.168.0.51
, as in the
following screenshot).
3. On step four of the Setup Wizard (Wireless), select
Client
from the drop-down list. Enter the same SSID and key
that you entered when configuring the first device.
4. To confirm that wireless connectivity between the two
devices is configured correctly, navigate to the
Status
page and check the information under
Associated
Stations
(shown below).
