DAP-1360
Wireless N300 Access Point & Router
User Manual
Configuring Device (Access Point Mode)
Client
On the
Wi-Fi / Client
page in the access point mode, you can configure the device as a client to
connect to a wireless access point.
The “client” function in the access point mode allows using DAP-1360 as a wireless client and a
wireless repeater.
To use the access point as a wireless repeater, you need to configure the same parameters of the
wireless connection (the name of the wireless network, encryption parameters, and the channel) for
DAP-1360 and the remote access point.
To use the access point as a wireless client, you need to configure the same channel of the wireless
connection for DAP-1360 and the remote access point. Other parameters of the wireless network of
DAP-1360 do not depend upon the settings of the remote access point.
Figure 52. Connecting DAP-1360 in the access point mode as a client.
To allow the devices from the LAN of DAP-1360 to obtain the IP addresses from the DHCP server
of the remote access point or network, it is necessary to disable the built-in DHCP server of the
device. To do this, proceed to the
Net / LAN
page; then in the
DHCP server
section, in the
Mode
drop-down list, select the
Disable
value and click the
Apply
button.
Page
72
of 270