11
EN / CZone Touch 10 Generation 2 User & Installation Manual
3.4
Connections
Warning! Before starting the installation, be sure to turn electrical power off. If power is left on
or turned on during the installation, fire, electrical shock, or other serious injury may occur. Be
sure that the voltage of the power supply is compatible with the unit.
Figure 5. Connections
1. Connect Ethernet to Router (Optional)
Run an ethernet cable from the Ethernet port on the Touch 10 to an ethernet port on the router, only if
the Touch 10 will be configured in Ethernet Mode for iPad connectivity.
2. Connect NMEA 2000 Network
Run NMEA2000 Drop cable from NMEA2000 port on Touch 10 to NMEA2000 backbone.
3. Connect DC Power Cable
The unit has a voltage rating 8 to 32V DC, hence it can be installed in either 12V or 24V systems.
1. Connect Red wire on DC Power Cable to Battery Positive (+) ensuring a 3 Amp fuse is
installed inline.
2. Connect Black wire on DC Power Cable to Battery Negative (-).
3. Plug the supplied power cable to the DC Power port on the Touch 10.
+
-
3A Fuse
BATTERY
2
1
3
To Network Router
(Optional)
To NMEA2000
Network
