This manual provides brief instructions for installing and connecting the CP9000 Comfort
Controller. Please download the supplementary Installation Manual and programming guides
from
http://www.cytech.biz/installation_and_programming.html
Please read this Quick Installation and Supplementary Installation manuals before installing
Comfort
Introduction to the Comfort PCB
Please refer to the Hookup Diagram on the Lid of the Comfort Enclosure
Comfort PCB
LED Indicators
D1 (Red) LED - If Steady, system is armed. If Flashing, system is in Alert or Alarm state.
D2 Green) LED - If Steady, system is disarmed. If Flashing, system is in Trouble State.
U4 File System Mismatch
On
On
U1 Fault, No Power, or UCM Programming cable is connected
Off
Off
Alarm, Disarmed
On
Flash
Alert/Alarm, Trouble
Flash
Flash
Alarm, Armed
Off
Flash
Armed, Trouble
Flash
On
Armed, Normal
Off
On
Disarmed, Trouble
Flash
Off
Disarmed, Normal
On
Off
STATUS
GREEN (D2)
RED (D1)
Connections - Analog Section (Right Half)
AC (JP51) - Connected to Transformer secondary 14VAC (NOT Mains Voltage)
BATT (JP52) - Connected to 12V 7AH Sealed Lead-Acid Battery via supplied Battery cable.
TEL IN (MJ51) - Connection to Telephone Line
TEL OUT (MJ52) - Connection to House phones.
KP MIC/VOICE (JP53) - connection to Keypads MIC/VOICE
DP MIC/VOICE (JP54) - connection to Door Stations MIC/VOICE
GSM (J54) - connection to UCM/GSM Module audio signals.
RGR (J57) - Ringer Board RGR05 mounting
Comfort II Quick Installation Guide
Page 1 of 12
