Cypress MB2198-01, Руководство по установке

Страница: 11 / 21

Setting up the Emulation System
F2MC-16FX Family, Emulator System MB2198-01 Installation Guide, Doc. No. 002-05547 Rev. *A 10
3.1.3 Sub-Clock
It is recommended to install a 32.768 kHz crystal and two capacitors (about 15 pF) directly to the Adapter Board.
See Figure 3-1.
To supply the Sub-clock from the user system, add an oscillator to the user system.
Please refer to the graphic above and to the Table 3-2 how to enable the Sub-Clock.
Table 3-2. Sub-Clock
Clock Supply
S3 S4 S5
X0 X1 CLKSEL0 CLKSEL1 X0A X1A
Sub-Clock on adapter-
board
*M *M
Port Port EML EML
Sub-Clock on target
system
*M *M
CLK CLK USR USR
*M
: see Main-Clock
3.1.4 C-pin switching
The C-pin can be supplied from the emulation system or from the user system. This is selected by jumper S1. If
S1 is set to EML, the capacitor on the adapter board is used. If the capacitance of the user board is to be used,
select position USR.
Please refer to Table 3-3 how to set the C-Pin.
Table 3-3. C-pin Switching
C-Pin Switching S1
Capacitance on adapter board EML
Capacitance on user system USR
3.1.5 Mount the Adapter Board on the Emulator
The MB2198-500 Adapter Board has two connectors (ADAPTER BOARD
CONNECTOR A and B) on the back,
which fit into the connectors of the
Emulator MB2198-01.
Pay attention that the small white
triangles on the side of the connectors
point together.