GALEP-Programmer
FR Family MB91460 Series, Flash Programming, Doc. No. 002-05153 Rev. *A
33
5.2.3
Serial Asynchronous Programming with GALEP-5 Programmer
For serial asynchronous programming also the ISP adapter is needed. Connect the starterkit via serial cable to
the DSBU9 connector on the ISP adapter. Do jumper settings on starterkit as described in following chapters
depending on your board type. Additionally set DTR signal as reset signal.
Figure 5-18: Serial Asynchronous Programming with GALEP-5 Programmer
Start the GALEP5 programmer software and use ‘Load’ command to load a bin or hex file. Select tab ‘Devices’
and browse to the correct device, e.g. MCU
Cypress
MB91F467D. Choose ASYNC for serial asynchronous
programming. Use ‘Select Device!’ button to accept current selection.
Use the functions now enabled on the bottom of the window to select action:
Program: write loaded mhx/bin-file to MCU
Verify: compare loaded file to Flash contents
Blank: do a blank check
Read: read-out Flash content
Erase: perform a chip erase
After selecting a operation, tab ‘Action’ is automatically activated. Press ‘Start’ button to start operation.
For further information on available settings in software and jumper settings on starterkits have a look at
‘Options”
‘MB91F467D Options” (or other MCU type) and ‘Device Help’.
