CYALKIT-E02 Solar-Powered BLE Sensor Beacon Reference Design Kit Guide, Doc. No. 002-11317 Rev. *C
48
5. Reference Design
This chapter introduces you to the Solar BLE Sensor hardware and firmware initially provided. It discusses features such as
the WSN with the BLE Beacon process.
5.1 Hardware Description
The Solar BLE Sensor has two modes: Demo mode and Timer mode. Refer to section
information. You can set these modes using SW1 on the Solar BLE Sensor. This section details the information for
S6AE103A.
Note:
When the Solar BLE Sensor is in the enclosure, use the sharp end of something like tweezers (not included in the kit) to
change the mode.
The following is the circuit of the S6AE103A energy harvesting PMIC. There are four main blocks to operate it. Refer to the
for detailed specifications. The schematic and board layouts are available at the following location:
<Install directory>\CYALKIT-E02 Solar-Powered BLE Sensor Beacon RDK\<version>\Hardware
1. Power input block
2. VOUT setting block
3. Storage and VOUT control block
4. Internal timer setting block
Demo Mode
(DM)
Timer Mode
(TM)
SW1
