Getting Started with EZ-
PD™ CCG3
Document No. 002-00210 Rev. *A
26
Figure 22. Saving Modified Configuration in EZ-PD Configuration Utility
Save As
Button
5.3
Program CCG3 Device with Updated Configuration Parameters Using the EZ-PD
Configuration Utility
This section describes how to update the configuration parameters of a CCG3 device using the EZ-PD Configuration
Utility. After the modified configuration table is saved, follow the steps below to update the configuration table in the
CCG3 device using the EZ-PD Configuration Utility.
1. Ensure steps 1 to 8 of the
Modify Configuration Parameters Using EZ-PD Configuration Utility
section are
successfully completed.
2. Select
Tools
>
Configure Device
A new window
Configure Device
opens where the
target device to be programmed can be selected. Select
Notebook
as the target device, select the appropriate
cyacd
file to be programmed, and then click on the
Program
. Note that since the
Normal Flashing
option was selected as shown in
, the selected configuration file updates the
configuration parameters of the firmware that is not running, i.e., the alternate firmware. This option also causes
the running firmware to be switched at the end of the configuration update. Therefore, in this case, the alternate
mode firmware will become the running firmware after the configuration update is complete and the device is
reset.
