Cypress Semiconductor CY3215-DK, Руководство пользователя

Страница: 21 / 38

CY3215-DK PSoC 1 In-Circuit Emulator Development Kit Guide, Doc. # 001-66514 Rev. *B 20
Using ICE-Cube Connector
To program the device, follow these steps:
1. Using a USB cable, plug the ICE-Cube into the installed application. Make sure the ICE-Cube is
powered on.
2. Connect the ISSP cable to the ICE-Cube through the backward compatibility adapter.
3. Place the 5-pin end of the ISSP cable on the 5-pin header(J2) of the MiniEval board.
4. Place the CY8C29466 chip on the MiniEval board via ZIF socket.
5. Launch PSoC Programmer.
6. Load the hex file using the File Load button.
7. Program it successfully.
Figure 3-12. Backward Compatibility Adapter Connected to ICE-Cube Pod
3.2.4 Debug a Project
To successfully debug a project, follow these steps:
1. Connect the ICE-Cube to the PSoC 1 development board.
2. Click Start > All Programs > Cypress > PSoC Designer <version> > PSoC Designer <ver-
sion>.
3. Create a new project in PSoC Designer by clicking File > New Project.
Note To open an existing project, click File > Open.
4. To connect the ICE-Cube and PSoC 1 development board, go to PSoC Designer > Debug.
5. Click on Connect/Disconnect or press F9.
6. Right-click on a line in the project from where the debugging process should start. The Insert/
Delete Breakpoint option appears.