Cypress Semiconductor CY3215-DK, Руководство пользователя

Страница: 15 / 38

CY3215-DK PSoC 1 In-Circuit Emulator Development Kit Guide, Doc. # 001-66514 Rev. *B 14
3. Using ICE-Cube Connector
3.1 Introduction
The CY3215-DK is used for prototyping and developing applications with PSoC Designer IDE. This
kit supports in-circuit emulation and the software interface allows access to the contents of specific
memory locations.
3.1.1 Software Installation
After the physical connection is made, you are ready to configure the internal connection from the
computer to the ICE. The ICE enables communication and debugging between PSoC Designer and
the pod. To connect the ICE from within PSoC Designer, perform the following steps:
1. Confirm that the flex cable and pod are attached to the ICE-Cube.
2. Confirm that the ICE is powered from the power adapter.
3. Confirm that the USB cable is connected from the ICE-Cube to the PC.
4. Create a project using PSoC Designer. For more information, see My First Code Example on
page 28 .
5. To access the debugger subsystem, go to Project > Settings > Debugger and click the
Debugger icon.
6. Select the correct port from the drop-down window. The target board may either be powered by
ICE-Cube or an external source. Select 5V as Pod Supply Voltage if the board is powered by
ICE-Cube.
7. Click OK.