CynkoMet T-149, Инструкция по использованию и эксплуатации

Страница: 45 / 148

Cynko Met
T-149
45

Check the condition of tires of the driving wheels and the air
pressure in the tires.
 Inspect the technical state of the flexible hydraulic hoses.

Check the technical condition of pneumatic cables.

Make sure that there are no leaks of hydraulic oil.

Check the electric lamps of lighting.
4.3.1.2 Preparation of the trailer for the first connection.
Preparation

Check all lubrication points of the trailer, if necessary, lubricate
the machine.

Check for proper tightening of nuts fixing the driving wheels.
 Dehydrate the air tank in the brake installation.

Make sure that the pneumatic, hydraulic and electrical
connections in the agricultural tractor comply with the
requirements, otherwise do not connect the trailer.

Adjust the height of the shaft location in the trailer or the
position of the upper transport hitch on the tractor.
Trial passage
If all the above steps have been performed and the technical
condition of the trailer does not raise any objections connect
the machine to the tractor. Start the tractor, inspect the
individual systems and carry out a test run of the trailer and
make a road test with no load (no loaded create). It is
recommended to carry out an inspection by two people, one
of them should reside in the operator's cab of the tractor. The
test run should be carried out in the order shown below.

Connect the trailer to an appropriate hitch in the agricultural
tractor.