ROTARY PERFORATING MACHINE RPM 350 PLUS
7
Right dot shows correct function of sensor of feeding table.
To find out if the sensor works correctly, we outshine it by piece of
paper. If the sensor is ok, the right dot stops shining.
6.5
Input feeding table adjustment (1)
Keep pushing the table to its lower position until the lever (20) falls into a designated slot and
secures the table in the same position. Set the T-squares (21) according to the width of
introduced sheets and secure the position of those sheets by the stop screws (23). When
introducing small-size sheets, always remember to center them to the table center. The central
point of the sheet should always bear on the center of the rubber washer (a). The previously
secured T-squares can be set into a transverse position by means of the nut (25) when minor T-
square corrections of about ± 5mm are required.
The perpendicularity of the T-squares to the table axis is set by means of the nut (26). Check
the ideal center position on the cross position mark (24). Support large size sheets by the
extension table piece (22).
Note: Sheets weighing 180 g/m² and more must be inserted one by one.
20
a
21
22
27
23
26
25
24
