Cellular Wireless Booster Installation Manual
Page 1 of 5
All brands and trademarks are the property of their respective owners.
©
2007,
Janizary Holdings, Inc. All rights reserved.
Rev B D000003
Designed and manufactured under license from Motorola, Inc. in the USA
Note: Before installing your Cyfre™ Wireless Booster, You Must Read the Entire Contents of this
Manual to Insure Proper Amplifier Operation and Performance.
Section # 1 WARNINGS!
∇
Antennas must be mounted a MINIMUM distance of 20 cm (7.87 inches) away from any person.
∇
An external antenna must be mounted outside a vehicle, boat, RV or home. If mounting an external
antenna on the exterior portion of the outside glass of a vehicle, a minimum of 6 feet of separation is
needed. Failure To do so may result in booster failure, and will void your warranty. Installation of this
system in a convertible style vehicle with less than 6 feet of horizontal antenna separation, and 3 feet of
vertical separation with a separation material of metal or fibreglass is not approved as of this time.
Installation on a small boat, or center console unit requires the external antenna to be mounted on a T-
Top, or other mounting surface at least six feet above the operator and at least six feet from the receive
antenna.
∇
UNDER NO CIRCUMSTANCES CAN AN EXTERIOR ANTENNA BE INSTALLED INSIDE A VEHICLE, boat,
RV or home. This action may result in amplifier failure, which will void your warranty.
∇
The power supply must be plugged into a 12 Volt outlet that is connected to the fuse box of your
vehicle, boat or RV and have a minimum of 3-amp fuse, or into a 120 volt AC to 12 volt DC converter.
∇
Under no circumstances should you power up your amplifier without first properly connecting a 50
ohm 800/ 1900 MHz dual band cellular antenna to both the internal and external antenna connectors.
Failure To properly connecting the antennas may result in amplifier failure, which will void your
warranty.
∇
For optimum performance and compatibility with your service provider requirements, it is
recommended that the external antenna be installed on the exterior metal roof of your vehicle, or on a
metal flat surface of at least two (2) square feet.
∇
Use of cellular amplifiers with exterior antennas of higher gain than 6dBi gain is in violation of FCC
regulations for which the offender will be fully liable, and void your warranty. Use of cellular amplifiers
with interior antennas of higher gain than 6dBi gain is in violation of FCC regulations for which the
offender will be fully liable, and void your warranty.
∇
Do not combine the external or interior antenna cable with another coaxial cables. The additional loss
of the cable length and connectors could greatly diminish the performance of the amplifier.
***It is recommended that only qualified or informed installation technicians install this product
permanently to a vehicle. Installation by any other person is at the risk of the owner and operator.
∇
Internal antennas must be mounted no closer than 20 cm
(7.87 inches) away from any person.
