Note: Before installing your Cyfre™ Wireless Booster, You Must Read the Entire
Contents of this Manual to Insure Proper Amplifier Operation and Performance.
Section # 1 Parts List
Item Qty Description
1 1
Small
Home/Building
Wireless
Booster
2
1
External Omni Directional
Antenna
3 1
120 VAC power supply
4 1
Interior mounted ceiling antenna
5
1
25ft length low loss cable
6 1
15 foot length low loss cable
Section # 2 WARNINGS!
•
External antennas must be mounted outside any building. If mounting an external antenna on the exterior portion of a
building, a minimum of 6 feet of vertical separation is needed between the antenna and booster. Failure To do so may
result in booster failure, and will void your warranty. The external antenna must be a MINIMUM distance of 40 cm
(15.75 inches) away from any person.
•
Internal antennas must be mounted a MINIMUM distance of 40 cm (15.75 inches) away from any person. The internal
antenna should be on top of the ceiling material so it can maintain that distance or greater.
•
All Installations must use the included 120-volt AC to 12-volt DC converter power supply. Failure to do so will void
your warranty.
•
Never power up your booster without first properly connecting the supplied internal and external antennas to the
booster. Failure to do so will void your warranty.
•
For optimum performance and compatibility with your service provider’s requirements, it is recommended that the
external antenna never be place near any windows.
•
Use of cellular boosters with exterior / interior antennas of higher gain than 5dBi is in violation of FCC regulations for
which the offender will be fully liable, and void your warranty.
•
Never combine external or interior antenna cables with other non-Cyfre coaxial cables. The additional cable length
and connections could greatly diminish the performance of the booster if using non-Cyfre cables.
•
Cyfre strongly recommends only qualified and informed installation technicians install this Cyfre strongly
recommends only qualified or informed installation technicians install this product. Installation by any other person is
at the risk of the owner and operator.
•
When installing an omni directional antenna the antenna must be a minimum of 18’ above any roofline or obstruction.
•
When installing an external Yagi antenna inside an attic space of a building the walls and roof area must be made of
wood, or wood with vinyl siding covering, asphalt style roof shingles, or cedar style roof shingles. This antenna will not
work if the exterior walls are brick or concrete, or the roof is of metal composition, or metal decking.
Содержание CWAP819
Страница 5: ......